Glow Plug Light (Diesel) on a Acura RLX
This is usually informational. Address it at your convenience.
What the Glow Plug Light (Diesel) Means on a Acura RLX
The glow-plug light on your diesel Acura RLX is your cue to wait a couple of seconds before starting in cold weather. A flashing light after the engine is running, however, indicates a fault the ECU wants checked.
How Urgent Is the Glow Plug Light (Diesel)?
In terms of priority, treat this as a low concern on your Acura RLX. The single most useful thing you can observe is whether the Glow Plug Light (Diesel) is steady or blinking: a steady light generally allows a careful drive to a safe location or a workshop, whereas a flashing light signals an active fault that can cause damage if you continue. Pay attention to changes in how the Acura RLX drives, sounds, or smells, since those symptoms sharpen the diagnosis considerably.
Common Symptoms Alongside the Glow Plug Light (Diesel)
Alongside the Glow Plug Light (Diesel), Acura RLX owners commonly report a handful of related signs. Some are obvious, others easy to miss until you pay attention. Keeping a short mental (or written) log of what the Acura RLX does when the light is on gives whoever performs the repair a huge head start and can save you money on diagnostic time.
- Light on briefly at cold start (normal)
- Flashing light after warm-up (fault)
- Hard starting when cold
- Rough running or white smoke on cold mornings
What Causes the Glow Plug Light (Diesel) to Come On?
Why did the Glow Plug Light (Diesel) come on in your Acura RLX? The honest answer is 'it depends', but the possibilities cluster into a recognisable set of causes. Knowing them in advance means you will not be caught off guard by a diagnosis, and it lets you sanity-check any repair quote against what commonly goes wrong on the Acura RLX.
- Normal pre-heat cycle (steady, brief)
- One or more failed glow plugs
- Glow plug relay fault
- Crankshaft/camshaft sensor issue
- Related engine management fault
How to Fix the Glow Plug Light (Diesel) on a Acura RLX
To resolve the Glow Plug Light (Diesel) on your Acura RLX, resist the urge to simply disconnect the battery and hope it stays off. A warning that is cleared without addressing the cause almost always returns. The step-by-step approach below is the same logical order a professional follows on the Acura RLX: confirm the basics, read the stored codes, then target the actual fault.
- At cold start, wait for the light to go out before cranking
- If it flashes, scan for glow-plug and engine codes
- Test each glow plug for resistance/continuity
- Replace failed plugs (ideally as a set) and check the relay
- Clear codes and confirm easy cold starts
Is It Safe to Drive With the Glow Plug Light (Diesel) On?
Whether it is safe to keep driving your Acura RLX with the Glow Plug Light (Diesel) on comes down to urgency (low) and behaviour. As a rule, if the light is red or flashing, or the Acura RLX is running poorly, stop somewhere safe and arrange help rather than pushing on. If the light is amber and the car drives normally, you generally have time to reach a workshop — but 'have time' is not the same as 'ignore it', so book a check promptly.
Diagnostic Trouble Codes Linked to the Glow Plug Light (Diesel)
If you scan a Acura RLX showing this light, these are the OBD-II trouble codes most commonly associated with it. The code you actually retrieve is what pinpoints the repair.
| Code | Meaning |
|---|---|
P0335 |
Crankshaft Position Sensor Circuit The crankshaft position sensor signal is faulty, which can cause stalling or a no-start condition. |
Professional Mechanic Tips
Hard cold starts plus a flashing glow-plug light on a diesel Acura RLX usually means one or more plugs have failed — replace them as a set for even starting.
Frequently Asked Questions
Why is the Glow Plug Light (Diesel) on in my Acura RLX?
On a Acura RLX, the Glow Plug Light (Diesel) comes on because a monitored value crossed a threshold the car considers abnormal. It could be a simple, inexpensive cause or a genuine fault — the only way to be sure is to scan the vehicle and interpret the codes rather than guess from the symbol alone.
Can I keep driving with the Glow Plug Light (Diesel) on?
It depends on the urgency (low) and how your Acura RLX is behaving. If the light is red or flashing, or the car drives differently, stop safely and get help. If it is amber and everything feels normal, you can usually drive to a workshop soon — just do not put off the diagnosis.
How much does it cost to fix the Glow Plug Light (Diesel) on a Acura RLX?
Repair cost for the Glow Plug Light (Diesel) on your Acura RLX depends entirely on the root cause. Because the same symbol covers cheap and expensive faults alike, a proper scan-based diagnosis is the best money you can spend — it turns a guess into a precise, fair quote.
Will the Glow Plug Light (Diesel) reset itself on a Acura RLX?
Sometimes the Glow Plug Light (Diesel) on a Acura RLX clears on its own once the condition that triggered it no longer exists — for example after several good drive cycles. More often, though, the light stays on until the underlying fault is repaired and the code is cleared, so treat a self-clearing light as a reason to still investigate.