Glow Plug Light (Diesel) on a Mitsubishi Lancer
This is usually informational. Address it at your convenience.
What the Glow Plug Light (Diesel) Means on a Mitsubishi Lancer
The glow-plug light on your diesel Mitsubishi Lancer is your cue to wait a couple of seconds before starting in cold weather. A flashing light after the engine is running, however, indicates a fault the ECU wants checked.
How Urgent Is the Glow Plug Light (Diesel)?
How worried should you be? For the Glow Plug Light (Diesel) on a Mitsubishi Lancer, the urgency is low. A good rule technicians rely on is 'colour plus behaviour': match the warning colour against how the car is actually performing. If the Mitsubishi Lancer still drives normally and the light is steady, you usually have time to plan a proper diagnosis; if performance drops or the light flashes, err on the side of caution and stop safely.
Common Symptoms Alongside the Glow Plug Light (Diesel)
Alongside the Glow Plug Light (Diesel), Mitsubishi Lancer owners commonly report a handful of related signs. Some are obvious, others easy to miss until you pay attention. Keeping a short mental (or written) log of what the Mitsubishi Lancer does when the light is on gives whoever performs the repair a huge head start and can save you money on diagnostic time.
- Light on briefly at cold start (normal)
- Flashing light after warm-up (fault)
- Hard starting when cold
- Rough running or white smoke on cold mornings
What Causes the Glow Plug Light (Diesel) to Come On?
Why did the Glow Plug Light (Diesel) come on in your Mitsubishi Lancer? The honest answer is 'it depends', but the possibilities cluster into a recognisable set of causes. Knowing them in advance means you will not be caught off guard by a diagnosis, and it lets you sanity-check any repair quote against what commonly goes wrong on the Mitsubishi Lancer.
- Normal pre-heat cycle (steady, brief)
- One or more failed glow plugs
- Glow plug relay fault
- Crankshaft/camshaft sensor issue
- Related engine management fault
How to Fix the Glow Plug Light (Diesel) on a Mitsubishi Lancer
To resolve the Glow Plug Light (Diesel) on your Mitsubishi Lancer, resist the urge to simply disconnect the battery and hope it stays off. A warning that is cleared without addressing the cause almost always returns. The step-by-step approach below is the same logical order a professional follows on the Mitsubishi Lancer: confirm the basics, read the stored codes, then target the actual fault.
- At cold start, wait for the light to go out before cranking
- If it flashes, scan for glow-plug and engine codes
- Test each glow plug for resistance/continuity
- Replace failed plugs (ideally as a set) and check the relay
- Clear codes and confirm easy cold starts
Is It Safe to Drive With the Glow Plug Light (Diesel) On?
Drivers ask this constantly, and the answer for the Mitsubishi Lancer is nuanced. A steady amber Glow Plug Light (Diesel) with no change in how the car drives usually means you can continue carefully and get it looked at soon. A red or flashing Glow Plug Light (Diesel), unusual noises, warning messages, or a drop in performance are your cue to stop the Mitsubishi Lancer safely and avoid further driving until the cause is known.
Diagnostic Trouble Codes Linked to the Glow Plug Light (Diesel)
If you scan a Mitsubishi Lancer showing this light, these are the OBD-II trouble codes most commonly associated with it. The code you actually retrieve is what pinpoints the repair.
| Code | Meaning |
|---|---|
P0335 |
Crankshaft Position Sensor Circuit The crankshaft position sensor signal is faulty, which can cause stalling or a no-start condition. |
Professional Mechanic Tips
Do not ignore a flashing glow light; on many diesels it doubles as a general engine fault warning, so scan it rather than guessing.
Frequently Asked Questions
Why is the Glow Plug Light (Diesel) on in my Mitsubishi Lancer?
Your Mitsubishi Lancer turned on the Glow Plug Light (Diesel) after its self-diagnostics flagged an issue in that system. Because several different faults can trigger the same symbol, the smart first move is an OBD-II scan to pull the specific code before you spend any money.
Can I keep driving with the Glow Plug Light (Diesel) on?
For a Mitsubishi Lancer, a steady amber Glow Plug Light (Diesel) with normal driving generally allows a careful trip to a garage. A red or flashing light, or any change in performance, means you should stop and avoid further driving until the fault is identified.
How much does it cost to fix the Glow Plug Light (Diesel) on a Mitsubishi Lancer?
There is no single price for the Glow Plug Light (Diesel) on a Mitsubishi Lancer; it ranges from a no-cost adjustment to a component replacement. The honest way to control cost is to diagnose the exact code before authorising any repair, so you only pay to fix what is actually wrong.
Will the Glow Plug Light (Diesel) reset itself on a Mitsubishi Lancer?
If the trigger was temporary, a Mitsubishi Lancer may turn the Glow Plug Light (Diesel) off automatically after a few drive cycles. If it remains lit, the vehicle is telling you the fault is still present, and the symbol will only go out for good once the cause is fixed.